Dell PowerConnect W-7200 Series Reference Manual page 1049

Parameter
Spanning Tree is...
VLAN membership
Switchport priority
Last clearing of "show interface
counters"
Port-channel 0 is...
#show interface port-channel 0 access-group
Port-Channel 0:
Port-Vlan Session ACL
---------------------
SessionACL
----------
The output of this command includes the following parameters:
Parameter
SessionACL
Vlan
Status
#show interface port-channel 0 counters
Port
PC 0:
Port
PC 0:
The output of this command includes the following parameters:
Parameter
PC
InOctets
InUcastPkts
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Vlan Status
---- ------
Description
Session ACL name.
VLAN number.
ACL status.
InOctets InUcastPkts
0
OutOctets OutUcastPkts
0
Description
Port number.
Number of octets received through the port.
Number of unicast packets received through the port.
Description
is indicated as shown in the display output above. If the LAG is created
by LACP, you can not statically add or delete any ports under that port
channel. All other commands are allowed. If LACP is not shown, then the
LAG is created by static configuration.
Spanning tree status on the specified port-channel.
Number of VLANs the specified port-channel is associated with.
Switchport priority of the specified port-channel.
Time since "show interface counters" was cleared.
Below the time, all current counters related to the specified port are
listed.
Whether or not this port-channel is trusted.
InMcastPkts
0 0
OutMcastPkts
0 0
InBcastPkts
0
OutBcastPkts
0
show interface port-channel | 1049