Command History
Release
ArubaOS 3.0
ArubaOS 3.2
ArubaOS 3.4
ArubaOS 5.0
ArubaOS 6.0
ArubaOS 6.1
ArubaOS 6.2
ArubaOS 6.2.1.0
Command Information
Platforms
All platforms, except for the
parameters noted in the Syntax table.
492 | provision-ap
Modification
Command introduced
Introduced support for the mesh parameters, additional antenna parameters, and AP
location parameters.
Introduced support for the following parameters:
installation
l
mesh-sae
l
set-ikepsk-by-addr
l
usb-dev
l
usb-dial
l
usb-init
l
usb-passwd
l
usb-tty
l
usb-type
l
usb-user
l
link-priority-cellular
l
link-priority-ethernet
l
The mesh-sae parameter no longer has the sae-default option. Use the sae-disable
option to return this parameter to its default disabled setting.
The uplink-vlan parameter was introduced.
The following new parameters were introduced for provisioning IPv6 APs:
dns-server-ip6
l
ip6addr
l
ip6prefix
l
gateway6
l
The following new parameters were introduced for provisioning APs in single-chain
mode:
sch-mode-radio-0
l
sch-mode-radio-1
l
The following new parameters were introduced for provisioning APs for 802.1X
authentication:
apdot1x-passwd
l
apdot1x-username
l
The following new parameters were introduced for provisioning Remote APs using USB
modems:
usb-modeswitch
l
4g-usb-type
l
The cellular_nw_preference parameter was introduced for provisioning multi-mode
modems, and the 4g-usb-type parameter was deprecated. Specify a 2/3G or 4G modem
type using the usb-type parameter.
Licensing
Base operating system, except for
the parameters noted in the Syntax
table.
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide