Dell PowerConnect W-7200 Series Reference Manual page 702

Parameter
Drop Broadcast and Multicast
WEP Key 1
WEP Key 2
WEP Key 3
WEP Key 4
WEP Transmit Key Index
WPA Hexkey
WPA Passphrase
Maximum Transmit Failures
BC/MC Rate Optimization
Rate Optimization for delivering EAPOL
frames
Strict Spectralink Voice Protocol (SVP)
802.11g Beacon Rate
802.11a Beacon Rate
Advertise QBSS Load IE
High throughput enable (SSID)
40 MHz channel usage
702 | show ap config
Description
the AP. If enabled, this feature converts multicast traffic to
unicast before delivery to the client, thus allowing you to set
a longer DTIM interval. The longer interval keeps
associated wireless clients from activating their radios for
multicast indication and delivery, leaving them in power-
save mode longer and thus lengthening battery life
If this feature is enabled on an AP, it drops all downstream
broadcast or multicast traffic to increase battery life.
Displays the static WEP key (1 of 4).
Displays the static WEP key (2 of 4).
Displays the static WEP key (3 of 4).
Displays the static WEP key (4 of 4).
Displays the key index that specifies which static WEP key
is to be used.
Displays the WPA pre-shared key (PSK).
Displays the WPA passphrase with which the AP generates
a pre-shared key (PSK).
Display the maximum number of transmission failures
allowed before the client gives up.
Shows if the AP has enabled or disabled scanning of all
active stations currently associated to that AP to select the
lowest transmission rate for broadcast and multicast
frames. This option only applies to broadcast and multicast
data frames; 802.11 management frames are transmitted at
the lowest configured rate.
Shows if the AP has enabled or disabled rate optimization
for delivering EAPOL frames.
Shows if strict Spectralink Voice Protocol (SVP) is enabled
or disabled.
Sets the beacon rate for 802.11g for APs use a Distributed
Antenna System (DAS). Using this parameter in normal
operation may cause connectivity problems.
Sets the beacon rate for 802.11a for APs use a Distributed
Antenna System (DAS). Using this parameter in normal
operation may cause connectivity problems.
Shows if the AP has enabled or disabled the advertising of
QBSS in the load IE.
Shows if the AP has enabled or disabled the use of its high-
throughput SSID in 40 MHz mode.
Determines if this high-throughput SSID allows high-
throughput (802.11n) stations to associate.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide