Dell PowerConnect W-7200 Series Reference Manual page 651

Port ACL Hits
-------------
ACL ACE New Hits
--- --- --------
5
The output of this command includes the following information:
Parameter
Role
Policy
Src
Dst
Service
Action
Dest/Opcode
New Hits
Total Hits
Index
ACL
ACE
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Total Hits Index
---------- -----
22
Description
Name of the role assigned by the ACL.
Name of the policy used by the ACL
The traffic source, which can be one of the following:
<alias> : Name of a user-defined alias for a network host, subnetwork, or range of
l
addresses.
any: match any traffic.
l
host: specify a single host IP address.
l
network: specify the IP address and netmask.
l
user: represents the IP address of the user.
l
The traffic destination, which can be one of the following:
<alias> : Name of a user-defined alias for a network host, subnetwork, or range of
l
addresses.
any: match any traffic.
l
host: specify a single host IP address.
l
network: specify the IP address and netmask.
l
user: represents the IP address of the user.
l
Network service, which can be one of the following:
IP protocol number (0-255)
l
name of a network service (use the show netservice command to see configured
l
services)
any: match any traffic
l
tcp: specify the TCP port number (0-65535)
l
udp: specify the UDP port number (0-65535)
l
Action if rule is applied, which can be one of the following:
deny: reject packets
l
dst-nat: perform destination NAT on packets
l
dual-nat: perform both source and destination NAT on packets
l
permit: forward packets
l
redirect: specify the location to which packets are redirected
l
src-nat: perform source NAT on packets
l
The datapath destination ID.
Number of ACL hits that occurred since this command was last issued.
Total number of ACL hits recorded since the controller last reset.
Index number of the ACL.
ACL number
ACE number
0
show acl hits | 651