Dell PowerConnect W-7200 Series Reference Manual page 1362

Parameter
Enable Handover
Trigger feature
Threshold signal
strength value at
which Handover
Trigger should be
sent to the client
Command History
This command was introduced in ArubaOS 6.2.
Command Information
Platforms
All platforms
1362 | show wlan handover-trigger-profile
Description
Shows if the handoff trigger feature is enabled of disabled. If enabled, the controller will
initiate the handover of a voice client (for example: dual mode handsets) roaming at the
edge of Wi-Fi coverage to an alternate carrier or connection. The handover trigger is
initiated if the Wi-Fi signal strength reported by the voice client (received from all APs) is
equal to or less than the threshold value.
Shows the threshold RSSI value below which a handover trigger message will be sent to
an associated client by the AP.
Licensing
Base operating system
Command Mode
Enable mode on master or local controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide