Snmp-Server - Dell PowerConnect W-7200 Series Reference Manual

snmp-server

snmp-server
community <string>
enable trap
engine-id
host <ipaddr> version {1 <name> udp-port <port>}|2c|{3 <name>} [inform] [interval
<seconds>] [retrycount <number>] [udp-port <port>]}
inform queue-length <size>
source
stats
trap enable|disable|{source <ipaddr>}
user <name> [auth-prot {md5|sha} <password>] [priv-prot {AES|DES} <password>]
Description
This command configures SNMP parameters.
Syntax
Parameter
community
enable trap
engine-id
host
version
inform
inform
stats
trap
disable
enable
source
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Sets the read-only community string.
Enables sending of SNMP traps to the configured host.
Sets the SNMP server engine ID as a hexadecimal number.
Configures the IP address of the host to which SNMP traps are sent.
This host needs to be running a trap receiver to receive and interpret
the traps sent by the controller.
Configures the SNMP version and security string for notification
messages.
Sends SNMP inform messages to the configured host.
Specifies the length for the SNMP inform queue.
Allows file-based statistics collection for MMS. The controller
generates a file that contains statistics data used by MMS to display
information in chart and graph formats.
File-based statistics collection is transparent to the user and increases
the efficiency of transferring information between the controller and
MMS.
Source IP address of SNMP traps.
Disables an SNMP trap. You can get a list of valid trap names using
the show snmp trap-list command.
Enables an SNMP trap.
Enter the source IP address for sending traps.
Range Default
— —
— disabled
24 characters —
maximum
— —
— —
— disabled
100-350 250
enabled
— disabled
— —
— —
— —
snmp-server | 1409