Dell PowerConnect W-7200 Series Reference Manual page 552

show remote-node-profile
show remote-node-profile
Description
The output of this command shows Remote Node profile configuration information.
Syntax
Parameter
remote-node-profile-name
Usage Guidelines
This show remote-node-profile command shows the configuration status of a Remote Node profile. To create a
Remote Node profile, use the remote-node-profile command to create a Remote Node profile.
Example
This example shows the configuration status of Remote Node profile named "test."
(host) #show remote-node-profile ?
<remote-node-profile-name>
|
<cr>
(host) #show remote-node-profile test
.......Vlan interface not configured for the controller-ip vlan.
.......No uplink information has been configured.
remote-node-profile test
remote-node-dhcp-pool newpool
pool-type tunnel 0
domain-name mycorp.com
range startip 0.0.0.0 endip 0.0.0.0 hosts 1
!
!
Related Commands
Command
remote-node-profile
Command History
Release
ArubaOS 6.0
552 | show remote-node-profile
Description
Name of the Remote Node profile
Profile name
Output Modifiers
Description
The remote-node-profile command lets you create a
Remote Node profile.
Modification
Command introduced
Mode
Config mode
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide