Table of Contents
Advertisement
Parameter
slb-update-interval <secs>
spectrum-load-bal-domain
spectrum-load-balancing
spectrum-monitoring
532 | rf dot11g-radio-profile
Description
that triggers load balancing. The default value is
20%, meaning that spectrum load balancing is
activated when there are 20% more clients on one
channel than on another channel used by the AP
radio.
Specify how often spectrum load balancing
calculations are made (in seconds). The default
value is 30 seconds.
Define a spectrum load balancing domain to
manually create RF neighborhoods.
Use this option to create RF neighborhood
information for networks that have disabled
Adaptive Radio Management (ARM) scanning and
channel assignment.
If spectrum load balancing is enabled in a
l
802.11g radio profile but the spectrum load
balancing domain is not defined, ArubaOS
uses the ARM feature to calculate RF
neighborhoods.
If spectrum load balancing is enabled in a
l
802.11g radio profile and a spectrum load
balancing domain isalso defined, AP radios
belonging to the same spectrum load
balancing domain will be considered part of
the same RF neighborhood for load balancing,
and will not recognize RF neighborhoods
defined by the ARM feature.
The Spectrum Load Balancing feature helps
optimize network resources by balancing clients
across channels, regardless of whether the AP or
the controller is responding to the wireless clients'
probe requests.
If enabled, the controller compares whether or not
an AP has more clients than its neighboring APs
on other channels. If an AP's client load is at or
over a predetermined threshold as compared to its
immediate neighbors, or if a neighboring Dell AP
on another channel does not have any clients,
load balancing will be enabled on that AP. This
feature is disabled by default.
NOTE: The spectrum load balancing feature
available in ArubaOS 3.4.x and later releases
completely replaces the AP load balancing feature
available in earlier versions of ArubaOS. When
you upgrade to ArubaOS 3.4.x or later, you must
manually configure the spectrum load balancing
settings, as the AP load balancing feature can no
longer be used, and any previous AP load
balancing settings will not be preserved.
Issue this command to turn an W-AP130 series AP
in ap-mode into a hybrid AP. An AP in hybrid AP
mode will continue to serve clients as an access
point while it scans and analyzes spectrum
analysis data for a single radio channel. For
further details on using hybrid APs and spectrum
Range
1-2147483647
seconds
—
—
—
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
30
seconds
—
disabled
default
Advertisement
Table of Contents
