Dell PowerConnect W-7200 Series Reference Manual page 728

show ap debug counters
show ap debug counters {ap-name <ap-name>|bssid <bssid>|group <group>|ip-addr <ip-addr>}
Description
Show AP reboot/bootstrap counters, and crash information for an individual AP or AP group, or all APs referenced on
the controller.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
group <group>
ip-addr <ip-addr>
Example
The output of this command shows how many times each AP has rebooted (a hard boot) or bootstrapped (a soft
boot), the number of configuration changes sent and acknowledged by that AP, and whether or not the AP rebooted
due to a kernel crash.
In this example, the output has been divided into multiple sections to better fit on the pages of this document. In
the actual command-line interface, it will appear in a single, long table.
(host) #show ap debug counters group corp1
AP Counters
-----------
Name Group IP Address
---- ----- ----------
AL1 corp1 10.6.1.209
AL10 corp1 10.6.1.198
AL12 corp1 10.6.1.200
AL15 corp1 10.6.1.197
AL16 corp1 10.6.1.199
AL19 corp1 10.6.1.212
AP Boots Acked
--------------
0
0
0
0
0
0
Total APs :6
The output of this command includes the following information:
728 | show ap debug counters
Description
Show debug counters for an AP with a specified name.
Show debug counters for a specific Basic Service Set Identifier (BSSID). The Basic Service
Set Identifier (BSSID) is usually the AP's MAC address.
Show debug counters for an AP group.
Show debug counters for an AP with a specified IP address by entering an IP address in
dotted-decimal format.
Configs Sent
------------
1597
165
195
1580
73
8
Bootstraps (Total) Reboots
------------------ -------
1 (1)
2 (2)
1 (1)
1 (1)
1 (1)
1 (1)
Configs Acked AP Boots Sent
------------- -------------
1597 0
165 0
195 0
1580 0
73 0
8 0
Crash
-----
0 N
1 Y
0 N
0 N
0 N
0 N
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide