Table of Contents
Advertisement
show interface vlan
show interface vlan
Description
Displays information about a specified VLAN interface.
Syntax
No parameters
Example
The example below shows the output of show interface vlan 1 on a W-650 controller.
#show interface vlan 1
VLAN1 is up line protocol is down
Hardware is CPU Interface, Interface address is 00:0B:86:61:82:40 (bia 00:0B:86:61:82:40)
Description: 802.1Q VLAN
Internet address is 10.3.49.50
Routing interface is enable, Forwarding mode is enable
Directed broadcast is disabled, BCMC Optimization disabled ProxyARP disabled Suppress ARP
disabled
Encapsulation 802, loopback not set
MTU 1500 bytes
Last clearing of "show interface" counters 4 day 0 hr 28 min 58 sec
link status last changed 4 day 0 hr 28 min 58 sec
Proxy Arp is disabled for the Interface
DHCP Option-82 mac and essid are configured on this Interface
The output of this command includes the following parameters:
Parameter
VLAN1 is...
line protocol is...
Hardware is...
Interface address is...
Description
Internet address is...
Routing interface is...
Forwarding mode is...
Directed broadcast is...
Encapsulation
1054 | show interface vlan
255.255.255.0
Description
Status of the specified VLAN
Displays the status of the line protocol on the specified port
Describes the hardware interface type
Displays the MAC address of the hardware interface
Description of the specified VLAN
IP address and subnet mask of the specified VLAN
Status of the routing interface
Status of the forwarding mode
Displays whether or not directed broadcast is enabled
Encapsulation type
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Advertisement
Table of Contents
