Dell PowerConnect W-7200 Series Reference Manual page 455

network-storage [deprecated]
network-storage [share <share-name>]
share [usb: disk <disk-name> <filesystem-path> mode {read-only | read-write}
no share
Description
This command allows you to perform the following operation on a network share:
Configure a file system path for the share–This allows users to access the share from their computer.
l
Remove the share access using the
l
Syntax
Parameter
share
Usage Guidelines
To access the share, you must create a filesystem path to the share. enter:
(host) (config-network-storage share)# share usb: disk <disk name> <filesystem path> mode
Where,
disk name is the name of the disk. You can also specify the disk alias instead of the disk name.
filesystem path is the path to access the share. This path contains the partition name and the shared folder name.
mode is the permission settings. You can either specify
Example
The following command associates a share to a file system path and configures the access mode.
(host) (config-network-storage share)#share usb: disk Maxtor1TB Maxtor-Basics_Desktop-
2HBADMJ4_p1/documents mode read-write
(host) (config-network-storage share)#show network-storage shares
NAS Shares
----------
Disk Name Partition Name
--------- --------------
Maxtor1TB MxDocs
p1/documents Read-Write
Command History
Release
ArubaOS 3.4
ArubaOS 6.2
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
command.
no share
Description
Enter a name for the share on the controller. After you enter this command, the CLI mode
will shift to operations on that share.
Folder Name Share Name
----------- ----------
Active
Modification
Command introduced.
Command deprecated.
or
read-only read-write
Share Path
----------
modes.
Share Mode Status
---------
network-storage [deprecated] | 455
------
docum