Dell PowerConnect W-7200 Series Reference Manual page 825

Column
Single chain mode for Radio
0
Single chain mode for Radio
1
IKE PSK
PAP password
PAP User Name
PPPOE User Name
PPPOE Password
PPPOE Service Name
PPPOE CHAP secret
USB User Name
USB Password
USB Type
USB Device Identifier
USB Dial String
USB Initialization String
USB TTY device data path
USB TTY device control path
Uplink VLAN
Link Priority Ethernet
Link Priority Cellular
Mesh Role
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
both: AP uses both antennas
l
If this parameter is set to 1 for an 802.11n-capable radio, the radio will operate in
single-chain mode, and will transmit and receive data using only legacy rates and
single-stream HT rates up to MCS 7. This parameter is set to 0 (disabled) by default.
If this parameter is set to 1 for an 802.11n-capable radio, the radio will operate in
single-chain mode, and will transmit and receive data using only legacy rates and
single-stream HT rates up to MCS 7. This parameter is set to 0 (disabled) by default.
IKE PSK The IKE pre-shared key.
Password Authentication Protocol (PAP) password for the AP.
PAP username for the AP.
Point-to-Point Protocol over Ethernet (PPPoE) user name for the AP.
PPPoE password for the AP.
PPPoE service name for the AP.
PPPoE CHAP secret key for the AP.
The PPP username provided by the cellular service provider
A PPP password, if provided by the cellular service provider
The USB driver type.
The USB device identifier.
The dial string for the USB modem. This parameter only needs to be specified if the
default string is not correct.
The initialization string for the USB modem. This parameter only needs to be
specified if the default string is not correct.
The TTY device path for the USB modem. This parameter only needs to be
specified if the default path is not correct.
The TTY device control path for the USB modem. This parameter only needs to be
specified if the default path is not correct.
If you configured an uplink VLAN on an AP connected to a port in trunk mode, the
AP sends and receives frames tagged with this VLAN on its Ethernet uplink.
By default, an AP has an uplink vlan of 0, which disables this feature.
Set the priority of the wired uplink, from 0-255. Each uplink type has an associated
priority; wired ports having the highest priority by default.
The priority of the cellular uplink, from 0-255. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary link and the
cellular link the secondary or backup link.
If the mesh role is "none," the AP is operating as a thin AP. An AP operating as a
mesh node can have one of two roles: mesh portal or mesh point.
show ap provisioning | 825