Dell PowerConnect W-7200 Series Reference Manual page 508

rename
rename <filename> <newfilename>
Description
This command renames an existing system file.
Syntax
Parameter
filename
newfilename
Usage Guidelines
Use this command to rename an existing system file on the controller. You can use a combination of numbers,
letters, and punctuation (periods, underscores, and dashes) to rename a file. The new name takes affect immediately.
Make sure the renamed file uses the same file extension as the original file. If you change the file extension, the file
may be unrecognized by the system. For example, if you have an existing file named
include the
.log
You cannot rename the active configuration currently selected to boot the controller. If you attempt to rename the
active configuration file, the controller returns the following message:
Cannot rename active configuration file
To view a list of system files, and for more information about the directory contents, see
Example
The following command changes the file named test_configuration to deployed_configuration:
(host) (config) #rename test_configuration deployed_configuration
Command History
This command was introduced in ArubaOS 1.0.
Command Information
Platforms
All platforms
508 | rename
Description
An alphanumeric string that specifies the current name of the file on the system.
An alphanumeric string that specifies the new name of the file on the system.
file extension.
Licensing
Base operating system
upgrade.log
"dir" on page
Command Mode
Eanble and Config modes on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
, the new file must
243.