Dell PowerConnect W-7200 Series Reference Manual page 715

show ap debug bss-config
show ap debug bss-config [ap-name <ap-name>|bssid <bssid>||essid <essid>|ip-addr <ip-
addr>|port <port>/<slot>]
Description
Show the configuration for each BSSID of an AP. This information can be used to troubleshoot problems on an AP.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
essid <essid>
ip-addr <ip-addr>
port <port>/<slot>
Examples
The output of this command shows the AP configuration table for a specific BSSID.
(host) #show ap debug bss-config
Dell AP Config Table
---------------------
bss
---
status wmm
------ ---
00:1a:1e:11:24:c2 cera2 66
enable enable
00:1a:1e:8d:5b:11 wpa2
enable enable
00:0b:86:9b:e5:60 guest 63
enable enable
00:1a:1e:97:e5:41 voip
enable enable
00:1a:1e:11:74:a1 voip
enable enable
00:1a:1e:11:5f:11 wpa2
enable enable
The output of this command includes the following information:
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Filter the AP Config table by AP name.
Filter the AP Config table by BSSID. The Basic Service Set Identifier (BSSID) is usually the
AP's MAC address.
Filter the AP Config table by ESSID. An Extended Service Set Identifier (ESSID) is a
alphanumeric name that uniquely identifies a wireless network. If the name includes
spaces, you must enclose the ESSID in quotation marks.
Filter the AP Config table by IP address by entering an IP address in dotted-decimal format.
Filter the AP Config table by port and slot numbers. The slot and port numbers should be
separated by a forward slash (/).
ess vlan ip
--- ---- --
10.6.1.203 g-HT ap
65 10.6.1.198 a-HT ap
10.6.14.79 g
66 10.6.1.199 g-HT ap
66 10.6.1.197 g-HT ap
65 10.6.1.200 a-HT ap
phy type fw-mode max-cl rates tx-rates preamble mtu
--- ---- ------- ------ ----- -------- -------- ---
tunnel 64
tunnel 20
ap tunnel 20
tunnel 20
tunnel 20
tunnel 20
0x3 0xfff enable
0x150 0xff0 -
0x2 0x3fe enable
0xc 0x14c enable
0xc 0x14c enable
0x150 0xff0 -
show ap debug bss-config | 715
0
0
0
0
0
0