show vrrp
show vrrp <vrid>
Description
Displays the list of all VRRP configuration on the controller. To view a specific VRRP configuration, specify the
VRID number.
Syntax
No parameters.
Example
The output of this command shows the VRRP configuration enabled in one of the floors of the building.
(host) # show vrrp
Virtual Router 2:
Description Floor-1 Settings
Admin State DOWN, VR State INIT
IP Address 10.15.1.10, MAC Address 00:00:5e:00:01:02, vlan 1
Priority 2, Advertisement 10 sec, Preemption Enable Delay 10
Auth type PASSWORD, Auth data: 123456
tracking type is master-up-time, duration 500 minutes, value 3
tracking type is vrrp-master-state, vrid 10, value 1
tracking type is vlan, vlanid 1, subtract value 3
tracking type is interface, fastethernet 1/1, subtract value 3
tracked priority 2
Command History
Version
ArubaOS 1.0
ArubaOS 3.3
ArubaOS 3.3.2
Command Information
Platforms
All platforms
1344 | show vrrp
Modification
Command introduced
The tracking interface and tracking vlan parameters were introduced.
The add option was removed from the tracking interface and tracking vlan parameters.
Licensing
Base operating system
Command Mode
Config or Enable mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide