Dell PowerConnect W-7200 Series Reference Manual page 870

show ap spectrum debug status
show ap spectrum debug status {ap-name <ap-name>}|{ip-addr <ip-addr>} freq-band 2.4ghz|5ghz
Description
This command shows detailed status and statistics for a spectrum monitor or hybrid AP.
Syntax
Parameter
ap-name <ap-name>
ip-addr <ip-addr>
freq-band
2.4ghz|5ghz
Usage Guidelines
Use this command under the guidance of an Dell technical support representative to troubleshoot spectrum analysis
errors.
Related Commands
Command
ap spectrum local-override
rf dot11a-radio-profilemodespectrum-
mode
rf dot11g-radio-profilemodespectrum-
mode
Command History
Introduced in ArubaOS 6.0.
Command Information
Platforms
All platforms
870 | show ap spectrum debug status
Description
Name of the spectrum device for which you want to view status information.
IP address of the spectrum device for which you want to view status information.
View information for a specific radio type, either 2.4 GHz or 5 GHz.
Description
Convert an AP or AM into a spectrum
monitor by adding it to the spectrum local-
override list.
Set a 802.11a radio so the device operates
as an spectrum monitor, and can send
spectrum analysis data to a desktop or
laptop client.
Set a 802.11g radio so the device operates
as an spectrum monitor, and can send
spectrum analysis data to a desktop or
laptop client.
Licensing
Base operating system
Mode
Config mode on master or local
controllers
Config mode on master or local
controllers
Config mode on master or local
controllers
Command Mode
Enable or Config mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide