show adp config
show adp config
Description
Show Aruba Discovery Protocol (ADP) configuration settings.
Syntax
No parameters.
Example
The following example shows that the controller has all default settings for ADP.
(host) #show adp config
ADP Configuration
-----------------
key
value
---
-----
discovery
enable
igmp-join
enable
igmp-vlan
0
The output of this command includes the following parameters:
Parameter
discovery
igmp-join
igmp-vlan
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Dell APs send out periodic multicast and broadcast queries to locate the master
controller. If the APs are in the same broadcast domain as the master controller and
ADP is enabled on the controller, the controller automatically responds to the APs'
queries with its IP address.
This command shows whether ADP is enabled or disabled on the controller.
Shows whether the controller has enabled or disabled the sending of Internet Group
Management Protocol (IGMP) join requests.
ID of the VLAN to which IGMP reports are sent. If this value is set to 0, the controller will
use the default route VLAN used.
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
show adp config | 653