Table of Contents
Advertisement
Column
IP Address
BSSID
Band/Ch/EIRP/MaxEIRP
MTU
Enet 0/1
Mesh Role
Parent
#Children
AP type
Uptime
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
782 | show ap mesh active
Description
IP address of the AP.
Basic Service Set Identifier (BSSID) for the AP. This is usually the AP's MAC address.
The RF band in which the AP should operate (a or g)/ Radio channel used by the AP/Current
effective Isotropic Radiated Power (EIRP) /maximum EIRP
Maximum Transmission Unit (MTU) size, in bytes. This value describes the greatest amount of
data that can be transferred in one physical frame.
Shows the current mode of each wired interface.
Bridge: 802.11 frames are bridged into the local Ethernet LAN.
l
Tunnel: 802.11 frames are tunneled to the controller using generic routing encapsulation
l
(GRE).
Split-tunnel: 802.11 frames are either bridged into the local Ethernet LAN or tunneled to
l
the controller, depending upon their destination.
Off: Interface is not available for serving clients.
l
If an AP has only one wired interface, the output of this command will display a dash (-) for
the unavailable port.
An AP operating as a mesh node can have one of two roles: mesh portal or mesh point.
If the AP is operating as a mesh point, this parameter displays the name of its parent mesh
portal. Mesh portals will display a dash (-).
If the AP is operating as a mesh portal, this parameter shows the number of mesh point
children associated with that mesh portal.
The AP model type.
Number of hours, minutes and seconds since the last controller reboot or bootstrap, in the
format hours:minutes:seconds .
Licensing
This show command is available in
the base operating system.
Commands to configure the secure
enterprise mesh solution for outdoor
APs require the Outdoor Mesh
license.
Command Mode
Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Advertisement
Table of Contents
