Dell PowerConnect W-7200 Series Reference Manual page 480

pptp ip local pool
pptp ip local pool <pool> <ipaddr> [<end-ipaddr>]
Description
This command configures an IP address pool for VPN users using Point-to-Point Tunneling Protocol (PPTP).
Syntax
Parameter
<pool>
<ipaddr>
<end-ipaddr>
Usage Guidelines
If VPN is used as an access method, you specify the pool from which the user's IP address is assigned when the user
negotiates a PPTP session. Use the show vpdn pptp local command to see the used and free addresses in the pool.
PPTP is an alternative to IPsec that is supported by various hardware platforms. PPTP is considered to be less
secure than IPsec but also requires less configuration. You configure PPTP with the vpdn command.
Example
The following command configures an IP address pool for PPTP VPN users:
(host) (config) #pptp ip local pool pptp-pool1 172.16.18.1 172.16.18.24
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
480 | pptp ip local pool
Description
User-defined name for the address pool.
Starting IP address for the pool.
Ending IP address for the pool.
Licensing
Base operating system
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide