Table of Contents
Advertisement
Country Code
ESSID
...
The output of this command includes the following information:
Parameter
BSSID
LMS IP
Master IP
Mode
QBSS Probe Response
Native VLAN ID
SAP MTU
Heartbeat DSCP
High throughput enable
(radio)
Channel
Beacon Period
Transmit Power
Advertise TPC Capability
Enable CSA
CSA Count
Management Frame Throttle
interval
Management Frame Throttle
Limit
Active Scan
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
US
guest
Description
The BSSID of the AP.
The LMS IP is the IP address of the local controller used by the AP for client
data processing.
For environments with multiple controllers, the master controller is the central
configuration and management point for all local controllers.
Shows the operating modes for the AP.
ap-mode: Device provides transparent, secure, high-speed data
communications between wireless network devices and the wired LAN.
am-mode: Device behaves as an air monitor to collect statistics, monitor
traffic, detect intrusions, enforce security policies, balance traffic load, self-
heal coverage gaps, etc.
Quality-of-service BSS (QBSS).
The ID number of the Native VLAN.
The Maximum Transmission Unit (MTU) for the GRE tunnel.
DSCP value for the heartbeat traffic between the AP and the controller.
Shows if high-throughput (802.11n) features on tare enabled or disabled on the
radio.
Shows the channel number for the AP's 802.11a/802.11n physical layer.
Shows the time, in milliseconds, between successive beacon transmissions.
The beacon advertises the AP's presence, identity, and radio characteristics
to wireless clients.
Shows the current transmission power level.
If enabled, the AP will advertise its Transmit Power Control (TPC) capability.
Displays whether or not the AP has enabled channel switch announcements
(CSAs) for 802.11h.
Number of channel switch announcements that must be sent before the AP
will switch to a new channel.
Average interval that rate limiting management frames are sent from this
radio, in seconds. If this column displays a zero (0), rate limiting is disabled for
this AP.
Maximum number of management frames that can come from this radio in
each throttle interval.
Displays whether or not the active scan feature is enabled.
This option elicits more information from nearby APs, but also creates
show ap debug received-config | 745
Advertisement
Table of Contents
