Table of Contents
Advertisement
show ap active
show ap active [ap-name <ap-name>|{arm-edge dot11a|dot11g|voip-only}|dot11a|dot11g|essid
<essid>|ip-addr <ip-addr>|ip6-addr <ip6-addr>|{type access-point|air-monitor|(sensor
dot11a|dot11g|voip-only)}|voip-only
Description
Show all active APs registered to a controller.
Syntax
Parameter
ap-name <ap-name>
arm-edge
dot11a
dot11g
voip-only
essid <essid>
ip-addr <ip-addr>
ip6-addr <ip6-addr>
type
access-point
air-monitor
sensor
voip-only
Usage Guidelines
This command displays details for all active APs on the controller. If an AP on your network does not appear in this
table, it may have been classified as an inactive AP for any of the following reasons:
The AP is configured with a missing or incorrect VLAN. (For example, the AP is configured to use a tunneled
l
SSID of VLAN 2 but the controller doesn't have a VLAN 2.)
The AP has an unknown AP group.
l
The AP has a duplicate AP name.
l
An AP with an external antenna is not provisioned with external antenna gain settings.
l
Both radios on the AP are disabled.
l
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
View data for an AP with a specified name.
Show the state of ARM edge APs.
Show 802.11a radio information.
Show 802.11g radio information.
Show AP information filtered by associated/active VoIP clients.
View data for a specific ESSID (Extended Service Set Identifier). An
Extended Service Set Identifier (ESSID) is a alphanumeric name that
uniquely identifies a wireless network. If the name includes spaces, you
must enclose the ESSID in quotation marks.
View data for an AP with a specified IP address by entering an IP address
in dotted-decimal format.
View data for an AP with a specified IPv6 address.
Show AP information filtered by type of AP.
Show information for Access Points only.
Show information for Air Monitors only.
Show only RFprotect Sensor information.
Show AP information filtered by associated/active VoIP clients.
show ap active | 655
Advertisement
Table of Contents
