Dell PowerConnect W-7200 Series Reference Manual page 1016

Debug Wireless Containment
Wired Containment
Wired Containment of AP's Adj MACs
Mobility Manager RTLS
IDS Event Generation on AP
Send Adhoc Info to Controller
The output of this command includes the following parameters:
Parameter
Stats Update Interval
Monitored Device Stats Update
Interval
AP Inactivity Timeout
Adhoc (IBSS) AP Inactivity
Timeout
AP Max Unseen Timeout
STA Inactivity Timeout
STA Max Unseen Timeout
Min Potential AP Beacon Rate
Min Potential AP Monitor Time
Signature Quiet Time
Wireless Containment
Debug Wireless Containment
Wired Containment
Wired Containment of AP's Adj
MACs
Mobility Manager RTLS
IDS Event Generation on AP
Send Adhoc Info to Controller
1016 | show ids general-profile
false
false
false
false
none
true
Description
Interval, in seconds, for the AP to update the controller with statistics. This
setting takes effect only if the Dell Mobility Manager is configured.
Otherwise, statistics update to the controller is disabled.
Time interval, in seconds, for AP to update the switch with stats for
monitored devices. Minimum is 60.
Time, in seconds, after which an AP is aged out.
Ad hoc (IBSS) AP inactivity timeout in number of scans.
Ageout time, in seconds, since AP was last seen.
Time, in seconds, after which a station is aged out.
Time, in seconds, after which an AP is aged out.
Minimum beacon rate acceptable from a potential AP, in percentage of
the advertised beacon interval.
Minimum time, in seconds, a potential AP has to be up before it is
classified as a real AP.
After a signature match is detected, the time to wait, in seconds, to resume
checking.
Shows if the profile has enabled or disabled containment from the
wireless side.
Shows if the profile has enabled or disable debugging of containment from
the wireless side.
Shows if the profile has enabled or disable containment from the wired
side.
Enable/disable wired containment of MACs offset by one from APs BSSID.
Shows if RTLS communication with the configured mobility-manager is
enabled or disabled.
Enable or disable IDS event generation from the AP. Event generation from
the AP can be enabled for syslogs, traps, or both. This does not affect
generation of IDS correlated events on the switch.
Enable or disable sending Adhoc information to the controller from the AP.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide