Dell PowerConnect W-7200 Series Reference Manual page 709

show ap database
show ap database {group <group>|inactive|indoor|local|long|outdoor|{page <page>}| sensors
[disconnected]|sort-by [ap-group|ap-ip|ap-type|fqln|provisioned|status {up|down}|switch-ip]
|sort-direction[ascending|descending]|start <start> |status {up|down]|switch <switch-ip-
addr>|unprovisioned|usb}
Description
Show the list of access points in the controller's database.
Syntax
Parameter
group <group>
inactive
indoor
local
long
outdoor
page <page>
sensors
disconnected
sort-by
ap-group
ap-ip
ap-type
fqln
provisioned
status up|down
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Show data for a specified AP group.
Show only local APs with no active BSSIDs or wired
AP interfaces.
Show only APs that have an installation mode set to "indoor."
Show only APs on this controller.
Display the following additional data columns:
Wired MAC Address,
l
Serial #
l
Slot/Port
l
FQLN
l
Show only APs that have an installation mode set to "outdoor."
Display a limited number of APs by entering the number of APs to be
displayed in the output of this command.
Show only RFprotect sensors.
Show only disconnected RFprotect sensors.
Sort the output of this command by a specific data column.
Sort by AP group name.
Sort by AP group name.
Sort by AP model.
Sort by Fully Qualified Location Name (FQLN).
Sort by provisioning statistics.
If used with the sort-by keyword, status sorts the output of the command by
status type (up or down.) Otherwise, use the status keyword to display APs
with the specified status.
show ap database | 709