Dell PowerConnect W-7200 Series Reference Manual page 506

Parameter
<id>
<start-ip>
<end-ip>
num_hosts
router ospf <area-id>
snmp-server
spanning-tree
syscontact <syscontact>
syslocation <syslocation>
uplink
validate
vlan
vrrp
Usage Guidelines
Use the remote-node-profile command to create a Remote Node profile. You define configuration settings for each
Remote Node through a Remote Node profile on the Remote Node-master. The Remote Node-master must be a
master controller.
506 | remote-node-profile
Description
or RN tunnels.
The ID number of the VLAN associated with the RN.
IP addresses at the start and end of the RN's address range, in dotted-
decimal format.
IP address at the end of the RN's address range, in dotted-decimal
format.
Maximum number of hosts supported by an RN using this pool.
Enables and configures OSPF. Configure an OSP area, control
distribution of default information, redistribute the route, configure the
Router ID and specific the subnet.
Enables SNMP and modifies SNMP parameters. For details on using
this command, see "snmp-server" on page
Create a Spanning Tree Subsystem. For details on using this
command, see "spanning-tree (Global Configuration)" on page
1411.
Configures the name of the system contact for the controller. Enter an
alphanumeric string that specifies the name of the system contact.
Configures the name of the system location for the controller. Enter an
alphanumeric string that specifies the name of the system location.
Define an uplink manager configuration. For details on using this
command, see "uplink" on page
After you have defined configuration settings for a Remote Node
profile, you must activate that profile by issuing the command remote-
node-profile <profile-name> validate to validate that the configuration
has a correctly defined uplink, model type, and an interface type
supported by the Remote Node model.
You cannot assign a Remote Node configuration profile to a Remote
Node until that profile has been activated.
Create a Remote Node VLAN Virtual Interface vlan. For details on
using this command, see "vlan" on page
Define a Virtual Router Redundancy Protocol (VRRP) configuration.
For details on using this command, see
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
1409.
1435.
1445.
"vrrp" on page 1463.