Dell PowerConnect W-7200 Series Reference Manual page 1168

show ntp peer
show ntp peer <a.b.c.d>
Description
Show NTP peer information.
Syntax
Parameter
<a.b.c.d>
Usage guidelines
The show ntp peer command is used for NTP server troubleshooting, and should only be used under the supervision
of Dell technical support. Issue the
servers.
Related Commands
To configure an NTP server, use the command
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
1168 | show ntp peer
Description
IP address of an NTP peer
show ntp servers command to view basic settings for currently configured NTP
ntp server.
Licensing
Base operating system
Command Mode
Enable and Config mode on local and master
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide