Dell PowerConnect W-7200 Series Reference Manual page 703

Parameter
MPDU Aggregation
Max transmitted A-MPDU size
Max received A-MPDU size
Min MPDU start spacing
Supported MCS set
Short guard interval in 20 MHz mode
Short guard interval in 40 MHz mode
Maximum number of spatial streams usable
for STBC transmission
Minimum number of spatial streams usable
for STBC transmission
Legacy stations
Allow weak encryption
Virtual AP enable
Allowed band
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Shows if the AP has enabled or disabled MAC protocol data
unit (MDPU) aggregation.
Shows the maximum size, in bytes, of an A-MPDU that can
be sent on the AP's high-throughput SSID.
Shows the maximum size, in bytes, of an Aggregated-MAC
Packet Data Unit (A-MPDU) that can be received on the
AP's high-throughput SSID.
Displays the minimum time between the start of adjacent
MDPUs within an aggregate MDPU, in microseconds.
Comma-separated list of Modulation Coding Scheme (MCS)
values or ranges of values to be supported on this high-
throughput SSID.
Shows if the AP has enabled or disabled use of short guard
interval in 20 MHz mode of operation.
Shows if the AP has enabled or disabled use of short guard
interval in 40 MHz mode of operation.
Controls the maximum number of spatial streams usable for
STBC transmission. 0 disables STBC transmission, 1 uses
STBC for MCS 0-7. Higher MCS values are not supported.
(Supported on the W-AP90, W-AP130 series, W-AP175
series, W-AP68 and W-AP105 only. The configured value
will be adjusted based on AP capabilities.)
Controls the maximum number of spatial streams usable for
STBC reception. 0 disables STBC reception, 1 uses STBC
for MCS 0-7. Higher MCS values are not supported.
(Supported on the W-AP90, W-AP130 series, W-AP175
series, W-AP68 and W-AP105 only. The configured value
will be adjusted based on AP capabilities.)
Shows if the AP has enabled or disabled the legacy stations
option, which controls whether or not legacy (non-HT)
stations are allowed to associate with the AP's SSID. By
default, legacy stations are allowed to associate.
NOTE: This setting has no effect on a BSS in which HT
support is not available.
Shows if the AP has enabled or disabled the weak
encryption option.
The use of TKIP or WEP for unicast traffic forces the use of
legacy transmissions rates. Disabling this mode prevents
the association of stations using TKIP or WEP for unicast
traffic. This mode is disabled by default.
Wireless LAN profiles configure WLANs in the form of
virtual AP profiles. This parameter shows if the AP has
enabled or disabled virtual APs.
Shows the band(s) on which to use the virtual AP:
a—802.11a band only (5 GHz)
l
g—802.11b/g band only (2.4 GHz)
l
show ap config | 703