Dell PowerConnect W-7200 Series Reference Manual page 895

Column
LMS Preemption
LMS Hold-down Period
Remote-AP DHCP Server VLAN
Remote-AP DHCP Server ID
Remote-AP DNS Server
Remote-AP DHCP Default Router
Remote-AP DHCP Pool Start
Remote-AP DHCP PoolEn
d
Remote-AP DHCP PoolNe
tmask
Remote-AP uplink total bandwidth
Remote-AP bw reservation 1Remote-AP bw
reservation 2Remote-AP bw reservation 3
Remote-AP Local Network Access
Bootstrap threshold
Double Encrypt
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
When this parameter is enabled, the local
management switch automatically reverts to the
primary LMS IP address when it becomes available.
Time, in seconds, that the primary LMS must be
available before an AP returns to that LMS after
failover.rap-dhcp-server-vlan VLAN ID of the remote
AP DHCP server used if the controller is
unavailable. This VLAN enables the DHCP server on
the AP (also known as the remote AP DHCP server
VLAN). If you enter the native VLAN ID, the DHCP
server is unavailable.
VLAN ID of the remote AP DHCP server used if the
controller is unavailable. This VLAN enables the
DHCP server on the AP (also known as the remote
AP DHCP server VLAN).
IP address used as the DHCP server identifier.
IP address of the DNS server.
IP address for the default DHCP router.
This parameter defines the starting IP address in the
DHCP pool for remote APs.
This parameter defines the last IP address in the
DHCP pool for remote APs.
Configures a DHCP pool for remote APs. This is the
netmask used for the DHCP pool.
This is the total reserved uplink bandwidth (in
Kilobits per second).
Session ACLs with uplink bandwidth reservation in
kilobits per second. You can specify up to three
session ACLs to reserve uplink bandwidth. The sum
of the three uplink bandwidths should not exceed
the rap-bw-total value.
Shows if Remote-AP Local Network Access is
enabled or disabled. By enabling this option, the
clients that are connected to a RAP can
communicate.
Note: By default, the Remote-AP Local Network
Access will be disabled.
Number of consecutive missed heartbeats on a GRE
tunnel (heartbeats are sent once per second on
each tunnel) before an AP rebootstraps. On the
controller, the GRE tunnel timeout is 1.5 x bootstrap-
threshold; the tunnel is torn down after this number
of seconds of inactivity on the tunnel.
This parameter applies only to remote APs. Double
show ap system-profile | 895