Dell PowerConnect W-7200 Series Reference Manual page 1410

Parameter
udp-port
user
auth-prot
priv-prot
Usage Guidelines
This command configures SNMP on the controller only. You configure SNMP-related information for APs in an
SNMP profile which you apply to an AP group or to a specific AP. To configure SNMP hostname, contact, and
location information for the controller, use the hostname, syscontact, and syslocation commands.
Example
The following command configures an SNMP trap receiver:
(host) (config) #snmp-server host 191.168.1.1 version 2c 12345678
Command History
Release
ArubaOS 3.0
ArubaOS 3.3.1
Command Information
Platforms
All platforms
1410 | snmp-server
Description
The port number to which notification messages are sent.
Configures an SNMPv3 user profile for the specified username.
Authentication protocol for the user, either HMAC-MD5-98 Digest
Authentication Protocol (MD5) or HMAC-SHA-98 Digest Authentication
Protocol (SHA), and the password for use with the designated
protocol.
Privacy protocol for the user, either Advanced Encryption Standard
(AES) or CBC-DES Symmetric Encryption Protocol (DES), and the
password for use with the designated protocol.
Modification
Command introduced
The stats parameter was introduced
Licensing
Base operating system
Range
—
—
MD5/SHA
AES/DES
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
162
—
SHA
DES