Show Lacp - Dell PowerConnect W-7200 Series Reference Manual

show lacp

show lacp <group_number> {counters | internal | neighbor}
Description
View the LACP configuration status.
Syntax
Parameter
<group_number>
counters
internal
neighbor
Example
The port uses the group number +1 as its "actor admin key". By default, all the ports use the long timeout value (90
seconds).
(Host)#show lacp 0 neighbor
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting fast LACPDUs
A - Device is in active mode P - Device is in passive mode
Partner's information
---------------------
Port Flags
---- -----
FE 1/1 SA
FE 1/2 SA
When a port, in a LAG, is misconnected (that is, the partner device is different than the other ports or the
neighborship times out or can not exchange LACPDUs with the partner), the port status is displayed as "DOWN"
(see the following example).
(Host)#show lacp 0 internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting fast LACPDUs
A - Device is in active mode P - Device is in passive mode
Port Flags
---- -----
FE 1/1 SA
FE 1/2 SA
The "counters" option allows you to view LACP received (Rx) traffic, transmitting (Tx) traffic, data units (DU)
received and transmitted by port.
1114 | show lacp
Description
Enter the Link aggregation group number.
Range: 0-7
Enter the keyword counters to view the LACP traffic.
Enter the keyword internal to view the LACP internal information.
Enter the keyword neighbor to view the LACP neighbor information.
Pri OperKey State Num
---- ------- ----- ---- ----------------
1 0x10 0x45 0x5
1 0x10 0x45 0x6
Pri AdminKey OperKey
---- -------- -------- ----- ---- -------
1 0x1 0x1
1 0x1 0x1
Dev Id
00:0b:86:51:1e:70
00:0b:86:51:1e:70
State Num Status
0x45 0x2 DOWN
0x45 0x3 UP
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide