Table of Contents
Advertisement
Parameter
maximum-distance
mgmt-frame-throttle-
interval
mgmt-frame-throttle-limit
mode
ap-mode
am-mode
spectrum-mode
no
radio-enable
slb-mode channel|radio
slb-threshold
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Maximum distance between a client and an AP or
between a mesh point and a mesh portal, in
meters. This value is used to derive ACK and CTS
timeout times. A value of 0 specifies default
settings for this parameter, where timeouts are
only modified for outdoor mesh radios which use a
distance of 16km.
The upper limit for this parameter varies,
depending on the 20/40 MHz mode for a 2.4GHz
frequency band radio:
20MHz mode: 54km
l
40MHz mode: 24km
l
Note that if you configure a value above the
supported maximum, the maximum supported
value will be used instead. Values below 600m
will use default settings.
Averaging interval for rate limiting management
frames in seconds. Zero disables rate limiting.
Note: This parameter only applies to AUTH and
ASSOC/RE-ASSOC management frames.
Maximum number of management frames allowed
in each throttle interval.
NOTE: This parameter only applies to AUTH and
ASSOC/RE-ASSOC management frames.
One of the operating modes for the AP.
Device provides transparent, secure, high-speed
data communications between wireless network
devices and the wired LAN.
Device behaves as an air monitor to collect
statistics, monitor traffic, detect intrusions, enforce
security policies, balance traffic load, self-heal
coverage gaps, etc.
Device operates as an spectrum monitor, and can
send spectrum analysis data to a desktop or laptop
client.
Negates any configured parameter.
Enables or disables radio configuration.
SLB Mode allows control over how to balance
clients. Select one of the following options:
channel: Channel-based load-balancing
l
balances clients across channels. This is the
default load-balancing mode
radio: Radio-based load-balancing balances
l
clients across APs
If the spectrum load balancing feature is enabled,
this parameter controls the percentage difference
between number of clients on a channel channel
Range
Default
0-24km
0 meters
(40MHz mode)
0-54km
(20MHz mode)
0-60
1 second
interval
0-999999
20 frames
per
interval
ap-mode
—
—
—
enabled
channel
1-100%
20%
rf dot11g-radio-profile | 531
Advertisement
Table of Contents
