Dell PowerConnect W-7200 Series Reference Manual page 535

rf event-thresholds-profile
rf event-thresholds-profile <profile>
bwr-high-wm <percent>
bwr-low-wm <percent>
clone <profile>
detect-frame-rate-anomalies
fer-high-wm <percent>
fer-low-wm <percent>
ffr-high-wm <percent>
ffr-low-wm <percent>
flsr-high-wm <percent>
flsr-low-wm <percent>
fnur-high-wm <percent>
fnur-low-wm <percent>
frer-high-wm <percent>
frer-low-wm <percent>
frr-high-wm <percent>
frr-low-wm <percent>
no ...
Description
This command configures the event thresholds profile.
Syntax
Parameter
<profile>
bwr-high-wm
bwr-low-wm
clone
detect-frame-
rate-anomalies
fer-high-wm
fer-low-wm
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Name of this instance of the profile. The name must be
1-63 characters.
If bandwidth in an AP exceeds this value, a bandwidth
exceeded condition exists. The value represents the
percentage of maximum for a given radio. (For 802.11b,
the maximum bandwidth is 7 Mbps. For 802.11 a and g,
the maximum is 30 Mbps.) The recommended value is
85%.
After a bandwidth exceeded condition exists, the
condition persists until bandwidth drops below this
value. The recommended value is 70%.
Name of an existing radio profile from which parameter
values are copied.
Enable or disables detection of frame rate anomalies.
If the frame error rate (as a percentage of total frames
in an AP) exceeds this value, a frame error rate
exceeded condition exists. The recommended value is
16%.
After a frame error rate exceeded condition exists, the
condition persists until the frame error rate drops below
this value. The recommended value is 8%.
Range Default
— "default"
0-100 0%
0-100 0%
— —
— disabled
0-100 0%
0-100 0%
rf event-thresholds-profile | 535