Dell PowerConnect W-7200 Series Reference Manual page 686

00:0b:86:9b:49:c0
0
Channel followed by "*" indicates channel selected due to unsupported configured channel.Num
APs:7
Num Associations:1
The output of this command includes the following information:
Column
bss
ess
s/p
ip
phy
type
ch/EIRP/max-EIRP
cur-cl
ap name
in-t(s)
tot-t
mtu
acl-state
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
686 | show ap bss-table
corp-ap 1/0 192.0.2.15
Description
The AP Basic Service Set Identifier (BSSID). This is usually the MAC address of the AP
The AP Extended Service Set Identifier (ESSID).
IP address of an AP.
An AP radio type. Possible values are:
a—802.11a
l
a-HT—802.11a high throughput
l
g— 802.11g
l
g-HT—802.11g high throughput
l
Shows whether the AP is working as an access point (AP) or air monitor (AM).
Radio channel used by the AP/current effective Isotropic Radiated Power (EIRP) /maximum EIRP.
Current number of clients on the AP.
Name of the AP.
Number of seconds that an AP has been inactive.
An AP's total active time, in seconds.
Maximum Transmission Unit (MTU) size, in bytes. This value describes the greatest amount of
data that can be transferred in one physical frame.
An access control list (ACL) can enable or disable an AP during specific time ranges.
Disabled: An ACL with time restrictions is currently disabled (so the AP is enabled).
l
Enabled: An ACL with time restrictions is currently enabled (so the AP is disabled).
l
This data column will display a dash (-) if no ACLs are currently configured for the AP.
l
Licensing
Base operating system
g ap
2m:0s 1578
Command Mode
Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
11/16.5/33
-