Table of Contents
Advertisement
show ap mesh debug meshd-log
show ap mesh debug meshd-log {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>} [<page>]
Description
Show the debug log messages for the meshd process.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
<page>
Usage Guidelines
This is an internal technical support command. Dell technical support may request that you issue this command to
help analyze and troubleshoot problems with the meshd process or your mesh network.
Command History
Release
ArubaOS 3.0
ArubaOS 3.4
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Show data for an AP with a specific name.
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic Service
Set Identifier (BSSID) is usually the AP's MAC address.
Show data for an AP with a specific IP address by entering an IP address in dotted-decimal
format.
Display page number 0, 1 or 2, where page 0 has the newest information and page 2 has the
oldest. If this parameter is omitted, this command will display all meshd log information,
oldest first.
Modification
Command introduced.
The page parameter was introduced.
Licensing
This show command is available in
the base operating system.
Commands to configure the mesh
feature require the Mesh license.
Command Mode
Enable or Config mode on master controllers
show ap mesh debug meshd-log | 791
Advertisement
Table of Contents
