Dell PowerConnect W-7200 Series Reference Manual page 838

show ap remote counters
show ap remote counters {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
Description
Show the numbers of message counters for Remote APs
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
Examples
Use this command to determine the number of message counters recorded for each counter type seen by the remote
AP. The output of the command in the example below shows counters for Remote AP State and VoIP CAC State
Announcements.
(host) #show ap remote counters ap-name al22
Counters
--------
Name
----
Remote AP State
VoIP CAC State Announcement
The output of this command includes the following information:
Column
Name
Value
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
838 | show ap remote counters
Description
Show data for an AP with a specific name.
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. You must specify an
AP's BSSID, which is usually the AP's MAC address
Show data for an AP with a specific IP address.
Value
-----
62851
13605
Description
Name of the counter type.
Number of counters recorded since the AP was last reset.
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide