Dell PowerConnect W-7200 Series Reference Manual page 843

show ap remote debug bss-config
show ap remote debug bss-config [ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>Description
Show the configuration for each BSSID of an AP. This information can be used to troubleshoot problems on an AP.
Syntax
Parameter
ap-name <ap-name>
ip-addr <ip-addr>
Examples
The output of this command shows the AP configuration table for a specific BSSID.
host) #show ap remote debug bss-config ap-name ap93-3
Dell AP Config Table
---------------------
bss
status wmm
---
------ ---
00:1a:1e:11:24:c2
enable enable
00:1a:1e:8d:5b:11
enable enable
00:0b:86:9b:e5:60
enable enable
00:1a:1e:97:e5:41
enable enable
00:1a:1e:11:74:a1
enable enable
00:1a:1e:11:5f:11
enable enable
The output of this command includes the following information:
Column
bss
ess
vlan
IP
phy
type
fw-mode
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Filter the AP Config Table by AP name.
Filter the AP Config Table by IP address by entering an IP address in dotted-decimal
format.
ess vlan
--- ----
cera2
wpa2 65
guest 63 10.6.14.79
voip 66 10.6.1.199
voip 66 10.6.1.197
wpa2 65 10.6.1.200
Description
Basic Service Set (BSS) identifier, which is usually the AP's MAC address.
Extended Service Set (ESS) identifier; a user-defined name for a wireless network.
The BSSID's VLAN number.
The AP's IP address.
One of the following 802.11 types
a
l
a-HT (high-throughput)
l
g
l
g-HT (high-throughput)
l
This column shows if the BSSID is for an access point (ap) or an air monitor (am).
The configured forward mode for the AP's virtual AP profile.
bridge: Bridge locally
l
ip phy type fw-mode
-- --- ---- -------
66
10.6.1.198 a-HT ap tunnel
g ap tunnel
g-HT ap tunnel 20
g-HT ap tunnel 20
a-HT ap tunnel 20
max-cl rates tx-rates
------ ----- --------
10.6.1.203 g-HT ap
20 0x150 0xff0
20 0x2 0x3fe enable
0xc 0x14c enable
0xc 0x14c enable
0x150 0xff0 -
show ap remote debug bss-config | 843
preamble mtu
-------- ---
tunnel 64
- 0
0
0
0
0