Dell PowerConnect W-7200 Series Reference Manual page 1357

Parameter
Interface
Regulatory Class
Channel
Randomization Interval
Measurement Duration
Measuremement Mode for Beacon
Reports
Reporting Condition
ESSID Name
Reporting Detail
Measurement Duration Mandatory
Request Information values
Command History
The command is introduced in ArubaOS 6.2.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Specifies the Radio interface for transmitting the Beacon Report Request
frame. It can have a value of either 0 or 1.
Specifies the Regulatory Class field in the Beacon Report Request frame.
Specifies the Channel field in the Beacon Report Request frame.
Specifies the Randomization Interval field in the Beacon Report Request
frame. The Randomization Interval is used to specify the desired maximum
random delay in the measurement start time. It is expressed in units of TUs
(Time Units).
Specifies the Measurement Duration field in the Beacon Report Request
frame. The Measurement Duration is set to the duration of the requested
measurement. It is expressed in units of TUs.
Specifies the mode used for the measurement. The valid measurement modes
are:
active-all-ch
l
active-ch-rpt
l
beacon-table
l
passive
l
Specifies the value for the "Reporting Condition" field in the Beacon Reporting
Information sub-element present in the Beacon Report Request frame.
Specifies the value for the "SSID" field in the Beacon Report Request frame.
Indicates the value for the "Detail" field in the Reporting Detail sub-element
present in the Beacon Report Request frame.
Specifies the "Duration Mandatory" bit of the Measurement Request Mode
field of the Beacon Report Request frame.
Indicates the contents of the Request Information IE that could be present in
the Beacon Report Request frame. The Request Information IE is present for
all Measurement Modes except the 'Beacon Table' mode. It consists of a list
of Element IDs that should be included by the client in the response frame.
Licensing
Base operating system
Command Mode
Enable mode on master or local controllers
show wlan bcn-rpt-req-profile | 1357