Dell PowerConnect W-7200 Series Reference Manual page 683

show ap blacklist-clients
show ap blacklist-clients
Description
Show a list of clients that have been denied access.
Usage Guidelines
Use the stm CLI command to add or remove users from a blacklist. Additionally, the dot1x authentication, VPN
authentication and MAC authentication profiles allow you to automatically blacklist a client if machine
authentication fails.
Examples
The output of this command shows that the controller has a single user-defined blacklisted client.
(host)# show ap blacklist-clients
Blacklisted Clients
-------------------
STA
---
00:1E:37:CB:D4:52
The output of this command includes the following information:
Column
STA
reason
block-time (sec)
remaining time(sec)
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
reason block-time(sec)
------ ---------------
user-defined
Description
MAC address of the blacklisted client.
The reason that the user was blacklisted.
user-defined: User was blacklisted due to blacklist criteria were defined by the network
l
administrator
mitm-attack: Blacklisted for a man in the middle (MITM) attack; impersonating a valid
l
enterprise AP.
ping-flood: Blacklisted for a ping flood attack.
l
session-flood: Blacklisted for a session flood attack.
l
syn-flood: Blacklisted for a syn flood attack.
l
session-blacklist: User session was blacklisted
l
IP spoofing: Blacklisted for sending messages using the IP address of a trusted client.
l
ESI-blacklist: An external virus detection or intrusion detection application or appliance
l
blacklisted the client.
CP-flood: Blacklisting for flooding with fake AP beacons.
l
UNKNOWN: Blacklist reason unknown.
l
Amount of time the client has been blocked, in seconds.
Amount of time remaining before the client will be allowed access to the network again.
remaining time(sec)
-------------------
2480
show ap blacklist-clients | 683