Table of Contents
Advertisement
Parameter
LMS Preemption
LMS Hold-down Period
Number of IPsec retries
LED operation mode
Master controller IP address
RF Band
Double Encrypt
Native VLAN ID
SAP MTU
Bootstrap threshold
Request Retry Interval
Maximum Request Retries
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
When this parameter is enabled, the local management
switch automatically reverts to the primary LMS IP address
when it becomes available.
Time, in seconds, that the primary LMS must be available
before an AP returns to that LMS after failover.
Shows the number of times the AP will attempt to recreate
an IPsec tunnel with
the master controller before the AP will reboot. The
supported range is
0-1000 retries, and the default value is 360. A value of 0
disables the
reboot.
The operating mode for the LEDs (11n APs only)
normal: Normal mode
l
off: All LEDs off
l
For multi-controller networks, this parameter displays the IP
address of the master controller.
For dual-band radios, this parameter displays the RF band in
which the AP should operate:
g = 2.4 GHz
l
a = 5 GHz
l
This parameter applies only to remote APs. Double
encryption is used for traffic to and from a wireless client
that is connected to a tunneled SSID. When enabled, all
traffic is re-encrypted in the IPsec tunnel. When disabled,
the wireless frame is only encapsulated inside the IPsec
tunnel.
Native VLAN for bridge mode virtual APs (frames on the
native VLAN are not tagged with 802.1q tags).
Maximum Transmission Unit (MTU) size, in bytes. This value
describes the greatest amount of data that can be
transferred in one physical frame.
Number of consecutive missed heartbeats on a GRE tunnel
(heartbeats are sent once per second on each tunnel)
before an AP rebootstraps. On the controller, the GRE tunnel
timeout is 1.5 x bootstrap-threshold; the tunnel is torn down
after this number of seconds of inactivity on the tunnel.
Interval, in seconds, between the first and second retries of
AP-generated requests. If the configured interval is less
than 30 seconds, the interval for subsequent retries is
increased up to 30 seconds.
Maximum number of times to retry AP-generated requests,
including keepalive messages. After the maximum number
of retries, the AP either reboots or tries the IP
address specified by the backup LMS IP address (if
configured).
show ap config | 693
Advertisement
Table of Contents
