Dell PowerConnect W-7200 Series Reference Manual page 1079

show ip nat pool
show ip nat pool
Description
Display pools of IP addresses for network address translation (NAT.
Syntax
No parameters
Examples
The example below shows the current NAT pool configuration on the controller.
(host) # show ip nat pools
NAT Pools
---------
Name Start IP
---- --------
2net
The output of this command includes the following parameters:
Parameter
Name
Start IP
End IP
DNAT IP
Related Commands
Command
ip nat
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
End IP
---------
2.1.1.1
Description
Name of the NAT pool.
IP address that defines the beginning of the range of source NAT addresses in the pool.
IP address that defines the end of the range of source NAT addresses in the pool.
Destination NAT IP address, if defined.
Description
This command configures a pool of IP addresses for network address translation (NAT).
Licensing
Though this command is available in the operating system, you must
have a PEFNG license to configure a NAT pool.
DNAT IP
-------
2.1.1.125
Command Mode
Available in Config or Enable
mode on master or local
controllers
show ip nat pool | 1079