Dell PowerConnect W-7200 Series Reference Manual page 909

show audit-trail
show audit-trail {<number>]
Description
Show the controller's audit trail log.
Syntax
Parameter
<number>
Example
By default, the audit trail feature is enabled for all commands in configuration mode. The example below shows the
most recent ten audit log entries for the controller.
(host) # show audit-trail 10
Feb 5 06:13:17
Feb 5 06:20:13
Feb 5 06:24:37
Feb 5 06:37:01
vap-enable > -- command executed successfully
Feb 5 06:37:14
vap-enable > -- command executed successfully
Feb 5 06:37:20
vap-enable > -- command executed successfully
Feb 5 06:37:29
vap-enable > -- command executed successfully
Feb 5 06:46:10
port monitor igigabitethernet "1/1" > -- command executed successfully
Feb 5 06:57:44
heartbeat-dscp 12 > -- command executed successfully
Feb 5 07:05:48
enable > -- command executed successfully
Related Commands
Enable or disable the audit trail feature using the command audit-trail.
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Start displaying the log output from the specified number of lines from the end of the log.
cli[1239]: USER: admin has logged in from 10.240.16.118.
cli[1239]: USER: admin connected from 10.240.16.118 has logged out.
cli[1239]: USER: admin has logged in from 10.240.16.118.
cli[1239]: USER:admin@10.3.129.250 COMMAND:<wlan virtual-ap "mp-only" no
cli[1239]: USER:admin@10.3.129.250 COMMAND:<wlan virtual-ap "mp-a-only" no
cli[1239]: USER:admin@10.3.129.250 COMMAND:<wlan virtual-ap "default" no
cli[1239]: USER:admin@10.3.129.250 COMMAND:<wlan virtual-ap "mpp-a-only" no
cli[1239]: USER:admin@10.3.129.250 COMMAND:<interface gigabitethernet "1/2"
cli[1239]: USER:admin@10.3.129.250 COMMAND:<ap system-profile "default"
cli[1239]: USER:admin@10.3.129.250 COMMAND:<wlan virtual-ap "mp-a-only" vap-
Licensing
Base operating system
Command Mode
Available in Enable and Config modes. Audit
trails can only be enabled on master
controllers
show audit-trail | 909