Dell PowerConnect W-7200 Series Reference Manual page 727

Parameter
MAC
ESSID
BSSID
Assoc_State
HT_State
AID
UAPSD
Tx_Pkts
Rx_Pkts
PS-Qlen
Tx_Retries
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
MAC address of a client.
Extended Service Set identifier (ESSID) used by the client. An ESSID is a user-defined name for a
wireless network.
Basic Service Set identifier for the client.
Shows whether or not the client is currently authorized and/or associated with the AP.
Shows the client's high-throughput (802.11n) transmission type:
none: AP is a legacy AP that does not support the 802.11n standard.
l
20Mhz: A high-throughput APs using a single 20 Mhz channel.
l
40Mhz: A high-throughput APs using two 20 Mhz channels.
l
802.11 association ID. A client receives a unique 802.11 association ID when it associates to an AP.
This parameter shows the following values for Unscheduled Automatic Power Save Delivery (UAPSD)
in comma-separated format: VO, VI, BK, BE, Max SP, Q Len.
VO: If 1, UAPSD is enabled for the VoIP access category. If UAPSD is disabled for this access
l
category, this value is 0.
VI: If 1, UAPSD is enabled for the Video access category. If UAPSD is disabled for this access
l
category, this value is 0.
BK: If 1, UAPSD is enabled for the Background access category. If UAPSD is disabled for this
l
access category, this value is 0.
BE: If 1, UAPSD is enabled for the Best Effort access category. If UAPSD is disabled for this access
l
category, this value is 0.
Max SP: The maximum service period is the number of frame sent per trigger packet. This value is
l
value can be 0, 2, 4 or 8.
Q Len: The number of frames currently queued for the client, from 0 to 16 frames.
l
Number of packets transmitted by the client.
Number of packets received by the client.
Power save queue length, in bytes.
Number of packets that the client had to resend due to an initial transmission failure.
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
show ap debug client-table | 727