show interface loopback
show interface loopback
Description
Displays information about the loopback IP interface.
Syntax
No parameters
Example
The example below shows the output of show interface loopback on a W-650controller.
#show interface loopback
loopback interface is up line protocol is up
Hardware is Ethernet, address is 00:0B:86:51:14:D0
Internet address is 10.3.49.100
The output of this command includes the following parameters:
Parameter
loopback interface
is...
line protocol is...
Hardware is...
address is...
Internet address is...
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
255.255.255.255
Description
Status of the loopback interface.
Status of the line protocol on the specified port.
Hardware interface type.
MAC address of the loopback interface.
IP address and subnet mask of the loopback interface.
Licensing
Base operating system
Command Mode
Enable or config mode on master controllers
show interface loopback | 1047