Dell PowerConnect W-7200 Series Reference Manual page 489

Parameter
pppoe-passwd
pppoe-service-
name
pppoe-user
read-bootinfo
reprovision
reset-bootinfo
sch-mode-radio-0
sch-mode-radio-1
server-ip
server-name
set-ikepsk-by-addr
syslocation
uplink-vlan <uplink-vlan>
usb-dev
usb-dial
usb-modeswitch "-v
<default_vendor> -p
<default_product> -V
<target_vendor> -P <target_
product> -M <message_
content>"
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Point-to-Point Protocol over Ethernet (PPPoE) password for the AP.
PPPoE service name for the AP.
PPPoE username for the AP.
Retrieves current provisioning parameters of the specified AP.
NOTE: This parameter can only be used on the master controller.
Provisions one or more APs with the values in the provisioning-params
workspace. To use reprovision, you must use read-bootinfo to retrieve
the current values of the APs into the provisioning-ap-list.
NOTE: This parameter can only be used on the master controller.
Restores factory default provisioning parameters to the specified AP.
NOTE: This parameter can only be used on the master controller.
If you are provisioning an 802.11n-capable AP, you can issue the sch-
mode-radio-0 command to enable single-chain mode for the selected
radio. AP radios in single-chain mode will transmit and receive data
using only legacy rates and single-stream HT rates up to MCS 7. This
setting is disabled by default.
If you are provisioning an 802.11n-capable AP, you can issue the sch-
mode-radio-1 command to enable single-chain mode for the selected
radio. AP radios in single-chain mode will transmit and receive data
using only legacy rates and single-stream HT rates up to MCS 7. This
setting is disabled by default.
IP address of the controller from which the AP boots.
DNS name of the controller from which the AP boots.
Set a IKE preshared key to correspond to a specific IP address.
User-defined description of the location of the AP.
If you configure an uplink VLAN on an AP connected to a port in trunk
mode, the AP sends and receives frames tagged with this VLAN on its
Ethernet uplink.
By default, an AP has an uplink vlan of 0, which disables this feature.
NOTE: If an AP is provisioned with an uplink VLAN, it must be connected
to a trunk mode port or the AP's frames will be dropped.
The USB device identifier, if the device is not already supported.
The dial string for the USB modem. This parameter only needs to be
specified if the default string is not correct.
USB cellular devices on remote APs typically register as modems, but
may occasionally register as a mass-storage device. If a remote AP
cannot recognize its USB cellular modem, use the usb-modeswitch
command to specify the parameters for the hardware model of the USB
cellular data-card.
NOTE: You must enclose the entire modeswitch parameter string in
quotation marks.
Range
—
—
—
—
—
—
provision-ap | 489