Dell PowerConnect W-7200 Series Reference Manual page 470

pcap (deprecated)
pcap {raw-start <ipaddr> <target-ipaddr> <target-port> <format> [bssid <bssid>] [channel
<number>] [maxlen <maxlen>]}|{interactive <am-ip> <filter> <target-ipaddr> <target-port>
[bssid <bssid>][channel <number>]}|{clear|pause|resume|stop <am-ip> <id> [bssid <bssid>]}
Description
These commands manage packet capture (PCAP) on Dell air monitors.
Syntax
Parameter
raw-start
<ipaddr>
<target-ipaddr>
<target-port>
<format>
bssid
<bssid>
channel
maxlen
<maxlen>
interactive
<am-ip>
<filter-spec>
<target-ipaddr>
<target-port>
bssid
<bssid>
channel
470 | pcap (deprecated)
Description
Stream raw packets to an external viewer.
IP address of the air monitor collecting packets.
IP address of the client station running Wildpacket's AiroPeek monitoring application.
UDP port number on the client station where the captured packets are sent.
Specify a number to indicate one of the following formats for captured packets:
0 : pcap
l
1 : peek
l
2 : airmagnet
l
3 : pcap+radio header
l
4 : ppi
l
(Optional) BSSID of the Air Monitor interface for the PCAP session.
BSSID of the Air Monitor Interface, which is usually its MAC address.
(Optional) Number of a radio channel to tune into to capture packets
(Optional) Limit the length of 802.11 frames to include in the capture to a specified maximum.
(Optional) Maximum number of packets to be captured.
Start an interactive packet capture session.
IP address of the air monitor collecting packets.
Packet Capture filter specification.
(Optional) Specify the BSSID of the Air Monitor interface for the PCAP session.
BSSID of the Air Monitor Interface, which is usually its MAC address.
(Optional) Number of a radio channel to tune into to capture packets
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide