Dell PowerConnect W-7200 Series Reference Manual page 515

Parameter
index
load-aware-scan-
threshold
max-tx-power
min-scan-time
min-tx-power
mode-aware
multi-band-scan
no
noise-threshold
noise-wait-time
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
channel. The denser the AP deployment, the lower
this value should be. Recommended value is 10.
Load aware ARM preserves network resources during
periods of high traffic by temporarily halting ARM
scanning if the load for the AP gets too high.
The Load Aware Scan Threshold is the traffic
throughput level an AP must reach before it stops
scanning. The supported range for this setting is 0-
20000000 bytes/second. (Specify 0 to disable this
feature.)
Maximum effective isotropic radiated power (EIRP)
from 3 to 33 dBm in 3 dBm increments. You may also
specify a special value of 127 dBm for regulatory
maximum to disable power adjustments for
environments such as outdoor mesh links. This value
takes into account both radio transmit power and
antenna gain.
Higher power level settings may be constrained by
local regulatory requirements and AP capabilities.
Minimum number of times a channel must be
scanned before it is considered for assignment. The
supported range for this setting is 0-2,147,483,647
scans. Best practices are to configure a Minimum
Scan Time between 1-20 scans.
Default: 8 scans
Minimum effective isotropic radiated power (EIRP)
from 3 to 33 dBm in 3 dBm increments. You may also
specify a special value of 127 dBm for regulatory
minimum. This value takes into account both radio
transmit power and antenna gain.
Higher power level settings may be constrained by
local regulatory requirements and AP capabilities.
If enabled, ARM will turn APs into Air Monitors (AMs)
if it detects higher coverage levels than necessary.
This helps avoid higher levels of interference on the
WLAN. Although this setting is disabled by default,
you may want to enable this feature if your APs are
deployed in close proximity (e.g. less than 60 feet
apart).
When enabled, single-radio APs try to scan across
bands for rogue AP detection.
Negates any configured parameter.
Maximum level of noise in a channel that triggers a
channel change (-dBm).
Minimum time in seconds the noise level has to
exceed the Noise Threshold before it triggers a
channel change.
Range Default
1250000
bytes/sec-
ond
3, 6, 9, 12, 15, 127 dBm
18, 21, 24, 27,
30, 33, 127
1-2,147,483,647 8 scans
Recommended
Values: 1-20
3, 6, 9, 12, 15, 9 dBm
18, 21, 24, 27,
30, 33, 127
— disabled
— enabled
— —
0-2,147,483,647 75 -dBm
Recommended
Values:
0-80 -dBm
1-3600 seconds 120 seconds
rf arm-profile | 515