Dell PowerConnect W-7200 Series Reference Manual page 1175

show packet-capture-defaults
show packet-capture-defaults
Description
Displays the status of default packet capture options.
Syntax
No parameters.
Example
The output of this command shows packet capture status.
(host) # show packet-capture-defaults
Current Active Packet Capture Actions(current switch)
=====================================================
Packet filtering for TCP ports disabled.
Packet filtering for UDP ports disabled.
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets disabled.
Packet Capture Defaults(across switches and reboots if saved)
============================================================
Packet filtering for TCP ports disabled.
Packet filtering for UDP ports disabled.
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets disabled.
Command History
This command was available in ArubaOS 3.3.2
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Licensing
Base operating system
Command Mode
Config or Enable mode on master or local
controllers
show packet-capture-defaults | 1175