show snmp user-table
show snmp user-table [user <username> auth-prot [sha | md5] <value> priv-prot [aes | des]
<value>]
Description
Displays the list of SNMP user profile for a specified username.
Syntax
Parameter
auth-prot
priv-prot
Example
The output of this command shows the list of SNMP traps sent to host.
(host) # show snmp user-table
SNMP USER TABLE
---------------
USER
AUTHPROTOCOL
----
------------
Sam
SHA
fire
SHA
Command History
This command was available in ArubaOS 3.0
Command Information
Platforms
All platforms
1268 | show snmp user-table
Description
Authentication protocol for the user, either HMAC-MD5-98 Digest Authentication Protocol (MD5) or
HMAC-SHA-98 Digest Authentication Protocol (SHA), and the password for use with the
designated protocol.
Privacy protocol for the user, either Advanced Encryption Standard (AES) or CBC-DES Symmetric
Encryption Protocol (DES), and the password for use with the designated protocol.
PRIVACYPROTOCOL
---------------
AES
AES
Licensing
Base operating system
FLAGS
-----
Command Mode
Config or Enable mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide