Dell PowerConnect W-7200 Series Reference Manual page 673

WIF Scan Time
-------------
channel last-scan-channel
------- -----------------
48 56/50655
The output of this command includes the following parameters:
Parameter
channel
Assign-time
scans-attempted
scans-rejected
dos-scans
flags
timer tick
last-scan-channel
current-scan-channel
last-dos-channel
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
current-scan-channel
--------------------
56
Description
A radio channel on the specified AP.
The amount of time that an AP has been on a channel.
The number of times an AP has attempted to scan another channel
The number of times an AP attempted to scan a channel, but was unable to scan because
the scan was halted by the power save, VoIP aware or load aware ARM features.
The number of times an AP enabled with the rogue aware scanning feature had to contain a
rogue device on a channel.
The flags column displays additional relevant information about the channel. The flags key
appears at the bottom of the Channel Scan Time table.
Timer tick at which the last scan was attempted.
The last channel scanned by the AP
The AP's current channel.
The last channel that had to be contained because a rogue device was detected on that
channel.
Licensing
Base operating system
last-dos-channel
----------------
0
Command Mode
Enable or Config mode on master controllers
show ap arm scan-times | 673