Dell PowerConnect W-7200 Series Reference Manual page 919

show cluster-switches
show cluster-switches
Description
Issue this command on a master controller using control plane security in a multi-master environment to show other
the other controllers to which it is connected.
Usage Guidelines
When you issue this command from the cluster root, the output of this command displays the IP address of the
VLAN used by the cluster member to connect to the cluster root.
If you issue this command from a cluster member ,the output of this command displays the IP address of the VLAN
used by the cluster root to connect to the cluster member.
Example
In the example below, the show cluster-switches command was issued on a cluster member. The Switch-IP section
of the output shows the IP address of a VLAN on cluster root, indicating that the cluster member can currently
communicate with the cluster root. If the member controller cannot communicate with the cluster root, this table
will be blank.
(host) (config) #show cluster-switches
SWITCH-IP
-----------------------------
172.21.18.18
In this example, the show cluster-switches command was issued on a cluster root. The Switch-IP section of the
output shows the IP address of a VLAN on each cluster member that can currently communicate with the cluster
root.
(host) (config) #show cluster-switches
SWITCH-IP
-----------------------------
172.21.18.18
172.21.18.19
Related Commands
Parameter
control-plane-security
cluster-member-ip
cluster-root-ip
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
CLUSTER-ROLE
ROOT
CLUSTER-ROLE
MEMBER
MEMBER
Description
Configure the control plane security profile.
This command sets the controller as a control plane security cluster
root, and specifies the IPsec key for a cluster member.
This command sets the controller as a control plane security cluster
member, and defines the IPsec key for communication between the
cluster member and the controller's cluster root.
Mode
Config mode
Config mode on
cluster root controllers
Config mode on
cluster member
controllers
show cluster-switches | 919