Table of Contents
Advertisement
Frame Retry Rate High Watermark
Frame Retry Rate Low Watermark
The output of this command includes the following parameters:
Parameter
Detect Frame Rate
Anomalies
Bandwidth Rate High
Watermark
Bandwidth Rate Low
Watermark
Frame Error Rate High
Watermark
Frame Error Rate Low
Watermark
Frame Fragmentation
Rate High Watermark
Frame Fragmentation
Rate Low Watermark
Frame Low Speed Rate
High Watermark
Frame Low Speed Rate
Low Watermark
Frame Non Unicast Rate
High Watermark
Frame Non Unicast Rate
Low Watermark
Frame Receive Error
Rate High Watermark
Frame Receive Error
Rate Low Watermark
Frame Retry Rate High
Watermark
Frame Retry Rate Low
Watermark
Command History
This command was available in ArubaOS 3.0.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
16 %
8 %
Description
Shows of the profile enables or disables detection of frame rate anomalies.
If bandwidth in an AP exceeds this value, it triggers a bandwidth exceeded condition.
The value represents the percentage of maximum for a given radio. (For 802.11b, the
maximum bandwidth is 7 Mbps. For 802.11 a and g, the maximum is 30 Mbps.) The
recommended value is 85%.
If an AP triggers a bandwidth exceeded condition, the condition persists until bandwidth
drops below this value.
If the frame error rate (as a percentage of total frames in an AP) exceeds this value, it
triggers a frame error rate exceeded condition.
If an AP triggers a frame error rate exceeded condition, the condition persists until the
frame error rate drops below this value.
If the frame fragmentation rate (as a percentage of total frames in an AP) exceeds this
value, it triggers a frame fragmentation rate exceeded condition.
If an AP triggers a frame fragmentation rate exceeded condition, the condition persists
until the frame fragmentation rate drops below this value.
If the rate of low-speed frames (as a percentage of total frames in an AP) exceeds this
value, it triggers a low-speed rate exceeded condition.
After a low-speed rate exceeded condition exists, the condition persists until the
percentage of low-speed frames drops below this value.
If the non-unicast rate (as a percentage of total frames in an AP) exceeds this value, it
triggers a non-unicast rate exceeded condition. This value depends upon the
applications used on the network.
If an AP triggers a non-unicast rate exceeded condition, the condition persists until the
non-unicast rate drops below this value.
If the frame receive error rate (as a percentage of total frames in an AP) exceeds this
value, it triggers a frame receive error rate exceeded condition.
If an AP triggers a frame receive error rate exceeded condition, the condition persists
until the frame receive error rate drops below this value.
If the frame retry rate (as a percentage of total frames in an AP) exceeds this value, it
triggers a frame retry rate exceeded condition.
If an AP triggers a frame retry rate exceeded condition exists, the condition persists until
the frame retry rate drops below this value.
show rf event-thresholds-profile | 1237
Advertisement
Table of Contents
